I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac
PDF) A Development of New Material for 4D Printing and the Material Properties Comparison between the Conventional and Stereolithography Polymerised NVCL Hydrogels
Z Compression Correction? - Form 3/3+ - Formlabs Community Forum
Advances in orthodontic clear aligner materials. - Abstract - Europe PMC
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
Microadditive Manufacturing Technologies of 3D Microelectromechanical Systems - Hassanin - 2021 - Advanced Engineering Materials - Wiley Online Library
Aerosol-Jet-Printed Graphene Immunosensor for Label-Free Cytokine Monitoring in Serum
DDL2021 Digital Proceedings by info-ddl-conference - Issuu
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
Z-Compression Correction question - General Discussion - Formlabs Community Forum
DDL2021 Digital Proceedings by info-ddl-conference - Issuu
Uncategorized
The RAPID 2013 Conference & Exposition Directory - Society of
Formlab 3 precision is worst than FDM - Form 3/3+ - Formlabs Community Forum
Polymers, Free Full-Text