First Layer Issues - Troubleshooting - V1 Engineering Forum

Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin

First Layer Problems – Assembly and first prints troubleshooting

3D Printing Layer Issues - Advice - V1 Engineering Forum

P1P Infill Tearing - Troubleshooting - Bambu Lab Community Forum

Well, I'm getting started! - Troubleshooting - V1 Engineering Forum

Diagnosing First Layer Problems : r/FixMyPrint

first layer problems after upgrade to MK3S – Assembly and first

First Layer Frustrations – Assembly and first prints

First layer issues – Assembly and first prints troubleshooting

First layer problem : r/BambuLab

Problem with 1st layer after changing layer height – Assembly and