O-rings norelem FR

O-rings are universal sealing elements used to seal against liquid or gaseous median. They are suitable for static and minor dynamic applications. O-rings can be used for radial and axial sealing. The sealing occurs during installation by the radial or axial compression of the cross-section. During operation, the median pressure increases the deformation of the O-ring and so increases the sealing effectiveness. For best sealing effectiveness, the O-ring should have the largest possible cross-section. During installation the correct groove size, compaction, elongation/compression should be ensured. By static use the compaction should be 15 - 30% of the cross-section. By dynamic use it should be 10 - 18% (hydraulic), 4 - 12% (pneumatic). With regard to the ID, when installed the O-ring should be stretched max 6% compressed max 3% The material NBR has a high wear resistance and is resistant to mineral oil based lubricating oils and grease, hydraulic oils (H, H-L, H-LP), high-flashpoint pressure fluids (HFA, HFB, HFC), aliphatic hydrocarbons, silicon oil and grease, water up to ca. 80° C

High-Quality O-Rings for Gaskets and Seals - Motion

Split Spring Pin split steel bright

Bow shackles

Joint torique NBR 106 x 3 - Shore 70, joint torique nbr

Captain O-Ring ORS Flat Face Hydraulic O-Ring Seal Kit (Buna 90

Self-aligning pads with O-ring and exchangeable inserts

Positioning table PT1408-PA with position indicator

Elastomer coupling - 23022-11 series - norelem - Éléments standard

Paulin 1/2 ID - 11/16 OD-inch Universal O-Rings - 2 pcs

KIPP - Ball-end thrust screws without head with full ball, LONG