Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement
Input Shaping without Klipper
More ringing with SuperSlicer vs Simplify3D 4.0 on Anycubic
How To Install Klipper On Creality Ender 3 S1: Config And Setup
Critique Input Shaper graphs and advice. : r/klippers
Input Shaper. - Page 2 – General discussion, announcements
Critique Input Shaper graphs and advice. : r/klippers
Klipper: Input Shaping – Simply Explained
Input Shaper without effect?! - General Discussion - Klipper
Klipper Tuning Guide - Get the Best Klipper experience on your Ender 3
Input Shaper issues? weirdness - General Discussion - Klipper