I would like to print the outer contour without extraction, and after that print the straight lines between the contour. I attached a picture how Cura does the slicing. It does several extractions
Slicing a Assembly as an individual component in Cura - UltiMaker
Settings to print inner and outer object separately ? - UltiMaker
slicing - Effect of top thickness on print with bumps on top - 3D
PDF) 3D Printing: Challenges and Its Prospect in Futuristic Tissue
Logo on outside wall disappearing when slicing in certain
Any reason Cura decides to break up a continuous line? : r/Cura
PDF) Helical tool path generation based on the triangle mesh model
Blog, XYZ dims *
Logo on outside wall disappearing when slicing in certain
How to force Cura slicer to perform orthogonal travel paths only
Selecting the Correct 3D Printing Infill Pattern in Cura
ultimaker cura - Internal wall does not print in horizontal print
Trouble with outer contour settings on cura. Why does it bubble
ultimaker cura - How to get a quality print of a thin single
Cura uses lines instead of concentric infill - 3D Printing Stack