is this a good first layer? - Improve your 3D prints - UltiMaker

hi. i just got done with a 47hr print which has a similar 1st layer to the one i'm showing here. the previous model was pretty stringy, the 1st layer is somewhat uneven feeling on the bottom, but other than that it's printed fairly well for 47hrs! so this is another component of the 47hr print, t

Tips & Tricks - Build Plate Adhesion

UltiMaker S3 Starter Bundle

Cura First Layer Settings: Initial Layer Simply Explained

Best Cura Plugins: Improve Your 3D Printing

3D Printing Troubleshooting: All Problems & Solutions

Help with getting correct first layer - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

ultimaker cura - Prusa i3 - First layer does not stick and looks jagged - 3D Printing Stack Exchange

Strange Pattern in first layer - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

3D Printing First Layer Problems: How to Make It Perfect

3D Printing 101: How to Succeed with a Perfect First Layer for Every 3D Print

Ultimaker 3 Forced Filament Fabrication Printers (FFF) - FUSE Makerspace

Cura First Layer Settings: Initial Layer Simply Explained

3D Printing 101: How to Succeed with a Perfect First Layer for Every 3D Print