Mesh inflation layer not shown - Project Support - SimScale CAE Forum

Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This

Inflation does not follow edge of airfoil

794 questions with answers in MESH

Top Simulation Software for 3D Printed Parts

speed regulation on motorways

SimScale - Another Fine Mesh

7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software

Simulation Software – Page 8

Inflation Layer - Project Support - SimScale CAE Forum

Week 3 - External flow simulation over an Ahmed body.

Mesh study external aerodynamics problem - Project Support - SimScale CAE Forum

Your Guide to Meshing Techniques for Efficient CFD Modeling

Resources, Free Full-Text

Tips & Tricks: Inflation Layer Meshing in ANSYS Computational Fluid Dynamics (CFD) Blog – LEAP Australia & New Zealand