Under-extrusion or gaps at seams with input shaper settings and 5

Page 2 | I have a mini+ but I think this issue might be on all Prusa printers with the recent input shaper enabled. Basically, there's ugly gaps at th

Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum

underextrusion - Seams of print are underextruded causing large pits/gaps? (Prusa Mk3+, Prusa Slicer) - 3D Printing Stack Exchange

Original Prusa MINI+, undefined

Pressure Advance doesn't seem to fix under extrusion issue - General Discussion - Klipper

3D Printer Under-Extrusion: 8 Simple Solutions

3D Printing Troubleshooting Guide

Pressure Advance doesn't seem to fix under extrusion issue - General Discussion - Klipper

Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum

print quality - Under extrusion when starting outer wall - 3D Printing Stack Exchange

Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum

Gaps in top and bottom layers, no under-extrusion - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum

Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum

Big gaps at z seam when using 0.8mm nozzle (underextrusion?) - General Discussion - Klipper

Under extrusion at seam (retraction settings)