Mesh split plane / mesh trim failing - Grasshopper - McNeel Forum

Hi guys, I’m having some problems splitting a mesh I have of a TPMS gyroid surface. It was created using millipede and then offset a small distance (not sure if that matters). When trying to split the mesh in 2 with an intersecting plane something odd happens. It does not split the mesh into 2 seperate meshes 1 above and 1 below the plane. It splits the mesh as shown in the picture below. Any insight on why this is happening would be greatly appreciated! here is the file with in

Mode Lab Grasshopper Primer Third Edition - Web - 96 PDF

Rhino/Grasshopper integration - BricsCAD BIM

Mesh split - Grasshopper - McNeel Forum

How to solve Mesh Split Problems? Help! :) - Grasshopper - McNeel

Toward Mass Customized Architecture. Applying Principles of Mass

Having troubles with plane trim mesh after fatten function

GrasshopperPrimer V3-3 en

ModeLab Grasshopper Primer Third Edition by Gil Akos & Ronnie

How can I split mesh by edges? - Grasshopper - McNeel Forum

Mesh split plane component fails - Grasshopper - McNeel Forum

Toward Mass Customized Architecture. Applying Principles of Mass